This is usually a basic setting offered in your router setting page. DHCP - Ensure DHCP is enabled on your router. If you can access the Internet from a computer on your network, try the following troubleshooting procedures: If these 3 actions do not succeed in correcting steadily blinking yellow/amber LED state, you will need to replace the device.Ī solid amber light means the FreeAgent Dockstar is not communicating with the Pogoplug service.įirst, verify your Internet connection is working properly. Disconnect and reconnect all the cables.Power down the unit, wait 20 seconds, then power the unit back on.This issue most commonly suggests a hardware failure, but there are 3 steps that you can try if your FreeAgent Dockstar’s LED is steadily blinking yellow/amber. Now, we will examine these LED States in more detail. The Seagate FreeAgent Dockstar failed to boot up normally. The Seagate FreeAgent Dockstar has booted up properly but failed to connect to the service. The Seagate FreeAgent Dockstar is on and correctly connected to the service. The Seagate FreeAgent Dockstar is booting up. The light on the front of the network adapter provides information about its current state and can help determine what steps to take in activating your device. Start by checking the status of the LED light on the front of the unit. If you are having trouble activating your FreeAgent Dockstar, this article should help you diagnose the issue.
0 Comments
Leave a Reply. |